Packet data access points
Select
Menu
>
Settings
and
Connectivity
>
Destinations
>
Access point
, and follow the instructions on
the screen.
To edit a packet data access point, open one of the access
point groups, and select an access point marked with
.
Follow the instructions from your service provider.
Select from the following:
Access point name — You obtain the access point name
from your service provider.
User name — The user name may be needed to make a data
connection, and is usually provided by your service provider.
Prompt password — If you must enter the password every
time you log in to a server, or if you do not want to save your
password in the device, select
Yes
.
Password — A password may be needed to make a data
connection and is usually provided by your service provider.
Authentication — Select
Secure
to always send your
password encrypted or
Normal
to send your password
encrypted when possible.
Homepage — Depending on the access point you are setting
up, enter the web address or the address of the multimedia
message centre.
Use access point — Select
After confirmation
if you want
the device to ask for confirmation before the connection
using this access point is created, or
Automatically
if you
want the device to connect to the destination using this
access point automatically.
Select
Options
>
Advanced settings
and from the
following:
Network type — Select the internet protocol type to transfer
data to and from your device. The other settings depend on
the selected network type.
Phone IP address (for IPv4 only) — Enter the IP address of
your device.
DNS addresses — Enter the IP addresses of the primary and
secondary DNS servers, if required by your service provider.
To obtain these addresses, contact your internet service
provider.
Proxy server address — Enter the address of the proxy
server.
Proxy port number — Enter the port number of the proxy
server.
© 2009 Nokia. All rights reserved.
68